How To Clean Your Swimming Pool
- Service Seo
- Jun 12, 2021
- 2 min read
Pool Cleaning Procedures
There are a few basic procedures that are efficient and save time which any one can follow. Determining the surface composition before starting the cleanup procedure.
Deck and Cover Cleaning
Remove as much debris as possible from the pool or spa deck and cover before removing it. A quick sweep or hosing can remove the debris near the pool. If the cover is a floating type without a roller system, be sure to fold or place it on a clean surface. Otherwise, when you put it back in place it will drag leaves, grass, or dirt into the pool. If it is a mechanized cover system, any small amount of standing water on top of the cover will slide off as you roll it up. If there is greater amount of water motor will be laboring, so you will need to use the water removal pump. Also be careful to avoid abrasive or sharp surfaces as you drag the cover off of the pool.
Surface Skimming
Dirt floating on the surface of the water is easier to remove than to remove it from the bottom. Remove floating debris off the surface, using a leaf rake and telepole. As the net fills, empty it into a trash can or plastic garbage bag. Do not empty your skimming debris into the garden or on the lawn for the debris is likely to blow right back into the pool as soon as it dries out.
There is no particular method to skim, but as you do, scrape the tile line, which acts as a magnet for small bits of leaves and dirt. The rubber-plastic edge gasket on the professional leaf rake will prevent scratching the tile.
If there is scum or general dirt on the water surface, squirt a quick shot of tile soap over the length of the pool. The soap will spread the scum toward the edges of the pool, making it more concentrated and easier to skim off.
Tiles
Always do the tiles first. Dirt falls from the tiles as they are being cleaned and settles to the bottom of the pool. If you need to remove stubborn stains with a pumice stone, the pumice itself breaks down as you scrub, depositing debris on the bottom.
Use the tile soap and tile brush to clean the tiles. Apply a squirt of tile soap directly to the brush and start scrubbing. To remove stubborn stains and oils, mix one part muriatic acid to five parts of soap. When cleaning tile, scrub below the waterline as well as above. Evaporation and refilling can change the water line. Never use really abrasive brushes or scouring pads to clean tiles they may cause scratches.
Water Level
If you add an inch or so of water to the pool each time you service it, you will probably keep up with normal evaporation. If you wait a few weeks until the level is several inches low, it will take hours to fill. Never leave the water on to fill by itself for it may take longer and most likely you may forget to turn it off.
f you liked this posting and you would like to obtain more information concerning California Pools kindly check out our web site.
Kommentare